Rov Reboot (3D Printed Rov)

[Oddmar]

How about using a Festo-style finger design for your gripper?

https://www.youtube.com/watch?v=90cXfaFM4O8

And the original idea from Festo which incoporates several ideas, including switching between 2-finger+ thumb mode, and 3-finger mode.

https://www.youtube.com/watch?v=u4ZScJsaepg

And a really complicated 5-finger hand one...lol.

https://www.youtube.com/watch?v=EcTL7Hig8h4

[sthone]

Very cool I just might have to give that a try... I'll bet there are some 3D printed ones out there already too.

-Steve

[DamascusDragon]

Dude,
After spending 45 years as a machinist / 5-8 axis cnc programmer / shop owner and 3D designer, I've become pretty jaded. Not much impresses me anymore. Your work impresses me. Thanks for posting it

[sthone]

Thanks,

I'm actually hoping to get back into this in the next week or two... so hopefully I'll have some progress to post.

-Steve

[sthone]

Reboot Rov Lights 001.jpg (112.72 KiB) Viewed 111696 times

Well its been longer than a week or two but maybe this is the year I finally finish this thing... Started work again with adding some lighting. I designed some brackets that will hold some external dive flashlights. These are simple mounts for now just for testing.

Reboot Rov Lights 002.jpg (135.24 KiB) Viewed 111696 times

The dive light will just be held in place on the bracket with some simple zip ties.

Reboot Rov Lights 003.jpg (142.7 KiB) Viewed 111696 times

I also designed some clip on shades to hopefully keep the light from scattering into the camera view.

-Steve

[sthone]

Reboot Rov Lights-004.jpg (661.83 KiB) Viewed 111690 times

Here is the printed bracket and the cheap 1100 Lumen Scuba Dive flashlight.

Reboot Rov Lights-005.jpg (892.5 KiB) Viewed 111690 times

The bracket just mounts to the same holes that hold the frame to the float pod.

Reboot Rov Lights-006.jpg (687.71 KiB) Viewed 111690 times

The strap bracket on the light fits into this tab on the bracket to keep it in place.

Reboot Rov Lights-007.jpg (746.8 KiB) Viewed 111690 times

Two zip ties will then keep everything in place.

Reboot Rov Lights-008.jpg (782.09 KiB) Viewed 111690 times

The angles will probably eventualy change but for now this should work for testing. I still need to print the other side and the shades.

-Steve

[sthone]

CUBE-Rebootl-162.jpg (778.17 KiB) Viewed 111284 times

I updated the bracket slightly just to keep the flashlight from spinning while trying to turn the end cap to turn it on.

CUBE-Rebootl-163.jpg (798.32 KiB) Viewed 111284 times

Here both diver lights have been mounted.

CUBE-Rebootl-164.jpg (664.31 KiB) Viewed 111284 times

They may be a little to spot lighty (is that a word?) but I’ll have to get it in the water to see how it looks. I may be able to fix this with different lens covers. The angles may need fixing also but I’ll wait till I get it in the water before I change anything.

-Steve

[JonnoLad]

Really cool project! It looks nice and streamlined. I especially like the camera setup, and the simplicity of using dive lights is a good idea.