Nice setup! I had a plan to print the whole ROV but had lots of difficulies with leakage.
I finally decided to go for acrylic plastic only using the printer for camera pan and tilt mount and motor mounts.
Search found 4 matches
- Oct 28th, 2014, 4:32 am
- Forum: Frames, Hulls, & Bouyancy
- Topic: A 3d printable ROV - Also, hello!
- Replies: 7
- Views: 11025
- Oct 15th, 2014, 4:33 pm
- Forum: Thrusters
- Topic: Hobbyking boat ESC
- Replies: 5
- Views: 5195
Re: Hobbyking boat ESC
Thanks. I will try that. Also tried a couple of old quad motors I had laying around. 1100kv Turnigy cheap stuff. Seemed to work much better.
- Oct 15th, 2014, 1:02 pm
- Forum: Thrusters
- Topic: Hobbyking boat ESC
- Replies: 5
- Views: 5195
Re: Hobbyking boat ESC
And what was your settings for:
fixed area acceleration
start mode
timing set
fixed area acceleration
start mode
timing set
- Oct 12th, 2014, 8:34 am
- Forum: Thrusters
- Topic: Hobbyking boat ESC
- Replies: 5
- Views: 5195
Hobbyking boat ESC
Does anyone use boat esc's from Hobbyking? I've been experimenting with 30A, 50A and 90A. They are extremely cheap but the quality not so good. Sometimes they break. Sometimes they cannot be programmed. Currently I use 50A esc but don't seem to get the programming right, eg punchmode. When I run the...