Mini CMOS FPV Camera set up
Posted: Jan 28th, 2015, 10:13 pm
my new camera arrived from HK. http://www.hobbyking.com/hobbyking/stor ... duct=64501
EzCap http://www.amazon.ca/gp/product/B004IRE ... ge_o00_s00
baluns http://www.pimfg.com/Product-Detail/NVA-700-WH-YL
Mini CMOS FPV Camera 520TVL 120deg Field Of Vision 0.008LUX 17x17x24mm (NTSC) To make sure everything works, I just used electrical tape for now. I started by cutting one end off an old rca cord. It has two wires; an inner, which is connected to signal/camera yellow and an outer, which is connected to ground/camera black.
Then I connected camera-plug ground/black to battery ground/black. And finally, camera power/red to battery power/red, adding a switch to make testing easier.
The yellow rca plug will plug into one balun, run down cat5 to a surface balun, and then plug into an EzCap connected to my laptop.
Here's a quick video.
https://www.youtube.com/watch?v=jxt93Fh ... e=youtu.be
EzCap http://www.amazon.ca/gp/product/B004IRE ... ge_o00_s00
baluns http://www.pimfg.com/Product-Detail/NVA-700-WH-YL
Mini CMOS FPV Camera 520TVL 120deg Field Of Vision 0.008LUX 17x17x24mm (NTSC) To make sure everything works, I just used electrical tape for now. I started by cutting one end off an old rca cord. It has two wires; an inner, which is connected to signal/camera yellow and an outer, which is connected to ground/camera black.
Then I connected camera-plug ground/black to battery ground/black. And finally, camera power/red to battery power/red, adding a switch to make testing easier.
The yellow rca plug will plug into one balun, run down cat5 to a surface balun, and then plug into an EzCap connected to my laptop.
Here's a quick video.
https://www.youtube.com/watch?v=jxt93Fh ... e=youtu.be