Hull Crawling Vehicle
-
TigerShark
- Posts: 108
- Joined: Jan 7th, 2014, 2:43 pm
- Location: Washington State
Re: Hull Crawling Vehicle
Beautiful design! I think cable glands should work fine and you could use aluminum or plastic enclosures with o ring seals. What prop is that you are using? It looks like a really good size, did you modify it?
-
ScottishTom
- Posts: 8
- Joined: Oct 11th, 2013, 7:21 am
Re: Hull Crawling Vehicle
@TigerShark,
Thanks very much, and like the idea for the plastic enclosures, will try that.
The propeller is a 4 Blade 95mm OD boat prop I bought from "Cornwall Model Boats" and only modification I did was drilling increasing the through hole size to about 10mm and cut two small tags off the bottom. Unreal power from it through that Outrunner Motor!
Cheers
Tom
Thanks very much, and like the idea for the plastic enclosures, will try that.
The propeller is a 4 Blade 95mm OD boat prop I bought from "Cornwall Model Boats" and only modification I did was drilling increasing the through hole size to about 10mm and cut two small tags off the bottom. Unreal power from it through that Outrunner Motor!
Cheers
Tom