Hello from the Great Lakes

[Mgbss]

First build, basically a flying Camera for inspections, absorbing all the info that I can. Biggest question at the moment is to use Bilge pump motors or figure out the brush-less route. Sizing for props vs Kvs

Thanks for the effort to build this site

Joe

[AHarris]

Good day, I am doing a similar build (in that I am going for a simple inspection before I add pincers and make it complicated e.t.c.).
I am using bilge pumps as it is very simple to do and requires little effort.

Good luck!

[Mgbss]

Hello

Been away for quite a bit, Finally getting back at my ROV thought I would say hello again

[scubersteve]

Well then...
Hello again!