Page 1 of 1

Hello Hello

Posted: Aug 6th, 2017, 5:59 pm
by Youngbrian48
Hello yall, anyone still active? Anyone in Florida? Ive been wanting to build an Rov for some time now. Ive already got one BR T200 thruster but I think I may start small since they aint cheap. Im tryin to come up with a first design. I love the look of the BR Rov but I cant find just the frame. Anyone know where I can get just the frame or have plans to cut out my own? If so what kind of plastic? Another question control, I know RC and all that. Ive been doing it for 7 yrs. Do you think I could run a tether through the rx antenna? Basically extend the antenna wire to 100m( my goal)

Re: Hello Hello

Posted: Aug 7th, 2017, 5:40 pm
by leeinmt
I'm using the older JR rc controllers with the DSC (direct servo control) jack in the back. It sends the radio signal through the tether wire to the receiver in the ROV. This was designed so that an rc operator could test his servos at the flying field without causing an active pilot to crash. Now that everyone has gone to 4 MHZ the DSC is no longer on the new radios.