Net Tool For ROV

Grippers, Grabbers, Cutters, Dredges, and any other Tools we can bolt on.
Post Reply
jcawesome
Posts: 20
Joined: Mar 24th, 2012, 10:39 am

Net Tool For ROV

Post by jcawesome »

I have an idea for a net attachment!!If you found some way to run some stiff rope through a net made with the mesh doubled over so it makes a loop and wound the rope around some sort of spool attached to a motor then you could open and close the mesh. Or you could attach a motor to it so it could rotate and close the net that way. Any ideas accepted. ;)

From,
Josh
ltdcruze
Posts: 47
Joined: May 3rd, 2011, 7:32 pm

Re: Net Tool For ROV

Post by ltdcruze »

May you please post a picture? I have been looking how to make an effective mesh.
jcawesome
Posts: 20
Joined: Mar 24th, 2012, 10:39 am

Re: Net Tool For ROV

Post by jcawesome »

The way I think is best is this(you will need fine mesh):
Cut a very elongated oval out of the mesh and split it in two
Measure the edge of the flat side and multiply that by two
Cut a strip of light cloth the a little longer than that
Sow the two halves of the mesh together tightly leaving the opening well, open
Fold the strip of cloth in half over the opening and hot-glue or sow them together

Hope it works,
Joshua :geek:
Post Reply