Affordable Syntactic Foam options or Macroballoon sources?

Waterproof Housing, Frames, and Buoyancy Methods.
User avatar
TigerShark
Posts: 108
Joined: Jan 7th, 2014, 2:43 pm
Location: Washington State

Re: Affordable Syntactic Foam options or Macroballoon source

Post by TigerShark »

After checking the Bluerobotics site, it looks like it would cost at least $100 to do my float. Too much unless it would be full depth capable (about 1500 feet in my case with safety factor) My max operating depth will be 1000'.
User avatar
sthone
Posts: 588
Joined: Nov 8th, 2010, 9:25 pm
Location: Connecticut
Contact:

Re: Affordable Syntactic Foam options or Macroballoon source

Post by sthone »

TigerShark wrote:My fiberglass covered foam insulation board didn't make it to 65 feet without crushing quite a bit. Lots of small bubbles when I brought it back up and it was a lot heavier!
Good to know, I kinda had a feeling that would happen... maybe I'll scrap that idea before I waste to much effort on it. I might just have to give that Blue robotics stuff a shot.

-Steve :sting:
Post Reply