I am trying to build an underwater rov with 4 inch PVC. I am stuck with leak proofing my end cap. I am attaching an Image of what I have. It is a threaded connection. I am looking for some ideas to prevent water leaks. I see that the stinger model shown in this site uses similar cap.
http://www.homebuiltrovs.com/stinger.html
Also the pressure champer also seem to use this end cap. http://www.homebuiltrovs.com/pressurechamber.html
Water proofing end cap
-
- Posts: 1
- Joined: Mar 1st, 2015, 9:23 am
Water proofing end cap
- Attachments
-
- PVCEndcap.jpg (39.29 KiB) Viewed 2915 times
- puzzler300
- Posts: 55
- Joined: Jan 2nd, 2013, 12:26 pm
- Location: St. Cloud, Mn
Re: Water proofing end cap
Plumbers tape. Put quite a bit on, the more the merrier. And then make sure it's tightened all they way down.