Cree xm-l T6 + constant current driver

Illuminating the Abyss.
Post Reply
Lost Bob
Posts: 28
Joined: Oct 7th, 2012, 9:50 pm

Cree xm-l T6 + constant current driver

Post by Lost Bob »

Here's what i am considering for lighting.

2 x Cree xm-l t6 https://www.amazon.ca/dp/B01KUXYTJE/ref ... R6DX3QPCSE
Image
1 x Drok constant current driver https://www.amazon.ca/dp/B00VUHVX6W/ref ... QLW8&psc=1
Image
It's a 70w driver so I can run both lights off it. The lights are 10w and 900 lm.

Or should I just get 2 of these https://www.amazon.ca/Flashlight-Dafana ... flashlight
Image
Good to 50m and 1200 lm.

Any thoughts or comments ?
User avatar
Oldsirhippy
Posts: 86
Joined: Oct 1st, 2013, 7:18 am

Re: Cree xm-l T6 + constant current driver

Post by Oldsirhippy »

Interesting problem.

The torch is great - but I found it needed to be switched on at the start of a mission and there is no easy way of dimming the light if required unless a complicated mechanical mechanism is built.

The Cree LED and PSU is the one I went for as the LED can be switched ON/OFF and dimmed.

I look forward to hearing which way you proceed and the solutions you implement.
Post Reply